add hw1.0 description and schematic
This commit is contained in:
parent
fc59ad34f9
commit
77f85bf159
@ -18,3 +18,7 @@ Kickstarter page: [kickstarter.com](https://www.kickstarter.com/projects/flipper
|
||||
* [Bluetooth](wiki/bluetooth.md)
|
||||
* [NFC](wiki/nfc.md)
|
||||
|
||||
## Hardware
|
||||
|
||||
* [Version 1.0](wiki/hw-1.0.md)
|
||||
* In progress Version 1.1
|
||||
|
BIN
wiki/flipper_zero_rev_1_0.pdf
Normal file
BIN
wiki/flipper_zero_rev_1_0.pdf
Normal file
Binary file not shown.
21
wiki/hw-1.0.md
Normal file
21
wiki/hw-1.0.md
Normal file
@ -0,0 +1,21 @@
|
||||
# Hardware version 1.0
|
||||
|
||||
[device schematic](wiki/flipper_zero_rev_1_0.pdf)
|
||||
|
||||
## Errata
|
||||
|
||||
* NAND reset IC drive reset net by push-pull output may cause MCU fault and disable internal MCU reset feature.
|
||||
* System going to boot-loop state when reset by reset circuit
|
||||
* No resistors on external gpio for protecting MCU
|
||||
* Wrong value LED series resistor
|
||||
* Wrong footprint for CMOS transistors
|
||||
* Wrong value IR TX series resistor
|
||||
* No need capacitor on IR RX
|
||||
* Wrong value IR RX pullup resistor
|
||||
* 125 kHz RFID + iButton wrong schematic
|
||||
* It seems bad to place main VCC on external GPIO pins. Overcurrent can damage main regulator and cause device broken. User can apply wrong voltage on this pin.
|
||||
|
||||
## New RFID + iButton schematic
|
||||
|
||||
after many experiments we found good schematic solution for work with RFID and auxiliary follow iButton level (for non-TTL protocol like Cyphral)
|
||||
|
Loading…
Reference in New Issue
Block a user