* Project: fix release build, replace asserts with checks.
* FuriHal: i2c refactoring, new bus access model, flexible bus gpio configuration.
* FuriHal: set i2c pins to high on detach.
* FuriHal: more i2c bus events, put bus under reset when not used, move bus enable/disable routine to bus handler.
* FuriHal: fix i2c deadlock in power api, add external i2c handle.
* USB-UART: new gui
* Furi: use furi_console for logging instead of printf.
* CDC: calling open/close callbacks on interface change
* fix vcp_tx block on disconnect
* USB mode set by struct pointer
* FuriHal: proper event sequence on vcp reconnect
* disable debug prints
* HAL: add context to UART IRQ's
* Context usage in UART IRQ and CDC callbacks
* USB-UART: geting rid of baudrate limitations
* FuriHal: remove struct pollutant in usb api.
Co-authored-by: あく <alleteam@gmail.com>
Co-authored-by: DrZlo13 <who.just.the.doctor@gmail.com>
* [FL-2010] furi-hal-vcp rework
* Fix connect state change on vcp enable
* New thread naming scheme and stack size adjustment.
* Applications: rename worker threads to match new naming scheme.
Co-authored-by: Aleksandr Kutuzov <alleteam@gmail.com>
- RPC: added CLI command to start session - all input bytes goes into RPC, all RPC output goes into VCP
- RPC: added command to close session (actually it only notifies transport layer)
- RPC: added recursive rmdir
- RPC: hard-coded listing for root directory (any, ext, int)
- Fixed CLI leak
- Fixed furi_record_delete leak
- Unit tests: repaired
- Unit tests: corrected output - remove excess, change dots with progress spinner
- Unit tests: added leak check
- Unit tests: SD mount check before start
Co-authored-by: Aleksandr Kutuzov <alleteam@gmail.com>
* USB-CDC: accepting the next data packet only if we process previous data
* USB-CDC: use USB FS packet size
* HAL-console: puts method
* Check: print assertion data
* FuriHal: rx stream free space aware CDC confirmation.
* Bootloader: pull down USB lines, leave the rest to the firmware or bootloader
* F6: cleanup and move USB code to usb-glue folder, add USB suspend/resume events to VCP, cleanup target.mk, fix missing motd message in cli when using minicom.
* F5: cleanup the rest of USB glue code, adjust LPM and Power info data in descriptor.
Co-authored-by: Aleksandr Kutuzov <alleteam@gmail.com>
