Hardware version 1.0

Errata

NAND reset IC drive reset net by push-pull output may cause MCU fault and disable internal MCU reset feature.
System going to boot-loop state when reset by reset circuit
No resistors on external gpio for protecting MCU
Wrong value LED series resistor
Wrong footprint for CMOS transistors
Wrong value IR TX series resistor
No need capacitor on IR RX
Wrong value IR RX pullup resistor
125 kHz RFID + iButton wrong schematic
It seems bad to place main VCC on external GPIO pins. Overcurrent can damage main regulator and cause device broken. User can apply wrong voltage on this pin.

after many experiments we found good schematic solution for work with RFID and auxiliary follow iButton level (for non-TTL protocol like Cyphral)