Minor documentation update to make it easier to understand. No changes to actual constants.
This commit is contained in:
24
rtengine/camconst.json
Normal file → Executable file
24
rtengine/camconst.json
Normal file → Executable file
@@ -262,18 +262,18 @@ the output). When you load a file you will see a message of current black
|
||||
and white levels and if they came from dcraw or camconst.json. If you're
|
||||
adjusting an existing camconst.json value you can just read what it is in
|
||||
the file and not need to enable verbose output. Reset exposure sliders to
|
||||
neutral, and zoom in on a clipped highlight. Move around the mouse pointer,
|
||||
it should show stable 100% on R G B. If so, the white level is not too high,
|
||||
it could however be too low. To test that, go to the raw tab and adjust the
|
||||
"whitepoint linear correction factor", reduce it until one of the channels
|
||||
is no longer 100%, and then increase 0.01 so all are 100 again. Usually you
|
||||
play around in the range 0.90 to 0.99, ie very small adjustment. Then divide
|
||||
the original white level with your adjustment to get a new larger white level,
|
||||
which you then enter in your camconst.json file. The same procedure can be
|
||||
used if the white level is too high, ie if you see pink highlights, then
|
||||
increase the correction factor above 1.0 until you just start seeing stable
|
||||
100% on all channels, and then divide the original white level to get a new
|
||||
smaller one.
|
||||
neutral, and zoom in on a large clipped highlight. Move around the mouse
|
||||
pointer within, it should show stable 100% on R G B. If so, the white level
|
||||
is not too high, it could however be too low. To test that, go to the raw tab
|
||||
and adjust the "whitepoint linear correction factor", reduce it until one of the
|
||||
channels is no longer 100%, and then increase in steps of 0.01 until all are 100
|
||||
again. Usually you play around in the range 0.90 to 0.99, ie a very small
|
||||
adjustment. Then divide the original white level with your adjustment to get a
|
||||
new larger white level, which you then enter in your camconst.json file. The
|
||||
same procedure can be used if the white level is too high, ie if you see pink
|
||||
highlights, then increase the correction factor above 1.0 until you just start
|
||||
seeing stable 100% on all channels, and then divide the original white level to
|
||||
get a new smaller one.
|
||||
|
||||
*/
|
||||
{"camera_constants": [
|
||||
|
Reference in New Issue
Block a user