flipperzero-firmware/wiki/hw/Hardware-specification.md
2020-08-15 09:57:12 +03:00

90 lines
1.3 KiB
Markdown
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

### Display
* Monochrome LCD
* Resolution: 128х64px
* Diagonal: 1.4”
* Orange LED backlight
### LED
RGB LED
### Control
* 5-button joystick
* Back button
* Reboot — Back+Left buttons for 2 seconds
### MCU
* ARM® Cortex®-M4
* 64 MHz
* 1MB (1M x 8) FLASH
### Sub-1 GHz Range
* СС1101
* TX/RX
* Frequency: 433/434/315/868 Mhz
* Modulation: ASK/FSK
### USB
* 1x USB 2.0 port, type C
* USB device
* Charging
### GPIO
* 0.65mm Female Header Connectors with 2.54 pitch
* x12+ — Data pins / 5V tolerant
* 2x — GND
* 1x — 3.3V
* 1x — 5V
### 125 khz RFID
* Supported protocols: EM-4100, HID Prox
* Operate modes: Reader/Writer/Emulator
### iButton 1-Wire
* Supported protocols: Dallas DS1990A, Cyphral, Metakom
* Operate modes: Reader/Writer/Emulator
### InfraRed
* Supported frequency: 36-40 kHz
* Operate modes: Reader/Emulator
### Bluetooth
* Bluetooth Low Energy 4.0+
* STM32WB55
### NFC
* Supported protocols: Mifare
* Operate modes: Reader/Emulator/Sniffer
### Vibro
* Type: Coin motor
* RPM: ≥10000
### Speaker
* Type: Coin
### Power and battery
* Built-in not removable lithiumion battery 2000mAh
* USB charging 5V, 500-2000mA
* ≥10 days standby
### Physical
* Materials: PC
* Weight: <200g
* Size: ~98х40х22mm
* Operating temperature: 0 ~ 50 °C